Rose Bud and Flower Pot Instructions

[OakleyDaisys]

Steps:
1. Start with the shorter piece of ribbon.
2. Loop it around and glue the ends together.
3. Glue the longer piece to the base where the first ribbon is jointed.
4. Loop it around just like the first piece and glue it down.
5. Take each leaf piece and fold it so it forms a loop but leaves 1/2" sticking out, glue it.
6. Glue the leaf piece onto the base of the flower leaving the 1/2" end sticking out.
7. Repeat with second leaf.
8. Flip over and glue the flaps down onto the back of the rose bud.
9. Glue to a lined alligator clip. Or in the case of the small rose bud I've glued it onto a 1.25" lined snap clip.






Steps:
1. Cut the sides of the 7/8" brown piece so that they are tapered. The top should measure 1" and the bottom around 3/4". Then glue the 3/8" brown ribbon along the top edge of the 7/8" brown piece.
2. Flip the piece over and glue the flaps down from the 3/8" brown piece.
3. Take the 1" piece of 1/4" ribbon and glue it in the middle of the lined alligator clip.
4. Glue the pot to the "pinch" end of the alligator clip. Glue the Small Rose Bud to the top of the stem.

*I hope you enjoy*

[jlalex]

That is beautiful. It looks easy. Thanks for sharing.

Jessica

[specialhome]

Thanks Amanda. Those arereally cute.
Melissa

[imadoll]

they are adorable!..and you know what they can even become great pins for mothers day!


thanks!

[ladybugmom]

Sooooo cute!!

[jymaldonado]

Love the flower pot

[jallison25]

These are great!!! I love this place!!!!!!!!!!!!!!!!!!!!

Jamie

[lroberts324]

So cute and just in time for spring!

[OakleyDaisys]

Thanks! I've had so much making tons of these. I was planning on doing instructions for something else but changed my mind at the last minute.

[cintb]

Thank you, I can't wait to make these!