Here is my version of the Princess Instructions. I wrote them as I was trying to figure out how to make the Princess. I hope they make sense.
Melissa
************************************************** *************
Princess Instructions
Step #1:
Gather and cut ribbon as follows:
3/8” flesh color for head and body = 4”
3/8” flesh color for arms = 2 ½”
3/8” lt. blue for sleaves = 2 pcs @1” each
3/8” lt. blue for skirt top = 2 pcs. @3 ½” each
3/8” lt. blue for skirt piece in middle = 4”
3/8” blue for waist =2”
3/8” blue for skirt = 2 pcs @4 1/8” each
3/8” yellow for hair curl = 2 ½”
3/8” yellow for hair = 2”
Step #2
Heat seal all of ribbon pieces except for the arms.
Step #3
Take the piece for the arms and fold like this. Put a small dot of glue in the fold.
I then put a clip on the fold to hold in until it dries while I go on to the next step.
Step #4
Take your piece for the head and body. Make a loop for the head at one end. Again I hold the loop with a clip while the glue dries.

side view
Step #5
Take your 4” lt. blue piece to start the skirt. Make a circle out of it. Glue the ends together.
Step #6
Get your 2 4 1/8” pieces of blue for skirt. Put a dot of glue on the top of your lt. blue circle and place 1 piece of blue on it like this.
Do the same thing on the other side with the 2nd piece of blue.
Step #7
Now take your 2 ends that are hanging and wrap them around the 1st circle and glue at the top. I put a small dab of glue on the bottom edge to hold the ribbon in place. You should have a skirt that looks like this.
Step #8
Now take your 2 lt. blue pieces for the skirt top and glue them just like the blue ones in Step #7. But this time they will not go to the bottom of the skirt only halfway. You should now have a skirt that looks like this. I have flattened the skirt between my fingers to make it look more like a skirt than a circle.
Step #9
Back to the arms. Cut your arm piece like this and then heat seal the edges.
Step #10
Take the 2 lt. blue pieces for the sleeves and glue on the back. It should look like this.
Step #11
Take the ribbon for your waist and your head and body piece. Wrap the waist piece around the body- not tight- about ¼ in. below the head and glue to the back of the body. Do not glue the front. It should look like this now.
Step #12
Take your arm piece and glue to the back of the body.
Step #13
Put glue down the body and center the skirt over the body. I like to put a small bead of glue at the bottom edge of the waist to glue it to the skirt so it does not leave a gap between the skirt and waist.
Step #14
Now for the hair. Take the longest piece of yellow and roll one end to make the curl in front. So now you have ribbon that looks like this.
Step #15
Glue the curl slightly to the front of the head.
Step #16
Glue the last piece on top of the head right behind the curl. Glue the ends of the ribbon behind the neck loosely.
Step #17
Take the ribbon sticking up on top of the head and roll it forward to make a bigger curl on top of her head. After you have glued the hair in place then glue onto a lined clip and you have a finished Cinderella clip.
These instructions were written by Melissa and may not be sold.