Hello guys, I post this one hoping I contribute to get enough the minimum number of entries for this contest.
You'll need:
3" red ribbon 7/8" , 1.5" white 3/8" and a white pompom for the hat,
1" light pink/cream 7/8" ribbon for the face (mine is a bit too pink so the Santa appears a bit drunken

)
1" white 3/8" ribbon for the moustache , you'll make two diagonal cut at the two ends and heat seal to get the look as pictured.
1.5" white 7/8" ribbon for the beard
2 joggle eyes, a little pink pom pom for the nose
Small piece of red ribbon die cut round for the mouth, and 2 small pieces of white ribbon die cut as two bushy eyebrows as pictured. (you can just simply cut them and heat seal with lighter. That's what I did. Of course a wood burner will work much better!)
Needle and thread
1/Use needle and thread to sew across that 1"white 3/8" as pictured
2/ pull the thread tightly to gather and secure

3/ Cut the 1.5" white 7/8" ribbon as pictured
4/ Use needle and thread and sew along the shorter edge, pull the thread tightly to gather and secure
5/ Make a round trim around that 90 degree corner, heat seal all the cut around the beard and glue the beard and moustache on to the red mouth, so that you will see just a bit of red underneath
6/Make two cuts to the 3" red 7/8" ribbon as pictured and heat seal
7/ Glue the white 3/8" ribbon to the bottom
8/ fold the two ends of the white ribbon to the back of the hat, making nice angles. glue!
9/ Fold the top of the hat to the front, glue to secure, apply the white pom pom to the top end
10/Glue the beard/mouth/moustache, joggle eyes, nose, two eyebrows and the hat onto the pink face. YOu're done
And thank you all to read this

Lynn