Hello everybody.
here they are. Please criticise!This is my improvisation. the tulip has actually a 3D look in real, I am not sure if it showed in photos. Do you think it can blend nicely with the new gymbo line as I am not so sure...
Thanks for looking.
Lynn
Here is my attemp for instruction. Hope you can understand me, I know I am no good at it. and sorry about the poor quality photos, I tried to crop them and it turned out big and blur.
1. heat seal two ends
2.
3.
4.
5.
6. steps 6, 12, 16, 18 : use the lighter to heat up the edges until they slightly melt, then quickly use your finger to press them together. they will blend into each other and stay fixed , better than if using glue. If you havn't got the effect after 1st time, do it again until theyare fixed together
7.
8.

9.

10.

11.

12.

13.

14.

15.

16.

17.

18.

19.

20.

21.

22. heat seal the edge

23.

24.Slightly run the lighter through and quickly use your finger to press

25. Use hot glue or fabric tac to glue flower and leaves to stem. here is your tulip.