Softball Glitter Headband Tut
I know many people make these things different ways, before anyone emails or posts anything, no one is saying your way is wrong!
I saw another thread going around asking for the softball headbands. I received this for free on this forum, so I am spreading the wealth. I have made these with materials purchased off ebay from Paper Street Plastics, and velvet from whoever has it cheapest!!
Just my $.02, I've tried the heat n bond method, but the band begins to pull apart near the girls ears where they pull on it the most. I've used E6000, with good results, it's just smelly and a little messy, especially with the tape having adhesive on it as well. But, for what it's worth:
Glam bands are made with glitter tape. The kind you buy for hula hoops and reflector items.
The cheapest place I have found glitter tape is www.identi-tape.com. <NOTE: I found it cheaper on ebay from Paper Street Plastics>
Cut your tape into strips…the typical size we used for the band is 21 inches unstretched for a middle school aged girl.. So we would cut the tape to 18 inches. Then cut a piece of backing to the same length… we used 7/8 black velvet for the backing. The glitter tape is 1 inch wide so you will have to trim down on the tape. I found it easier to trim at the end. The cheapest place by far to get 7/8 inch velvet is united bead.
You will need a fusible webbing to bond the glitter tape to the velvet. The glitter tape is sticky but you will want to make sure it bonds. We used 7/8 inch heat bond to bond the glitter tape to the velvet.
You are going to iron the heat n bond to the backside of the velvet. Once it cools peel the paper from the heat n bond leaving the webbing on the backside of the velvet. I use a mesh guard under my iron since velvet is pretty tricky to iron without matting it down. <NOTE: I never knew nor found out what a mesh guard was, didn't spend any time trying either, I just used an old tshirt like I do with my cheer bows>
Next you are going to adhere the glitter tape to the back of the velvet with the heat n bond to the sticky back of the tape. Once you have stuck the tape to the velvet, you will again need to iron in order for the glitter tape to bond with the velvet. Run the iron over several times to ensure there are no bubbles and you have a good stick.
This is when I trim the excess glitter tape that is over hang on the side.
Now you should have 1 piece of 20 inch glitter ribbon with a velvet back.
Next you are going to cut your elastic. I used ¾ inch non roll black elastic that I found a good price on eBay for. Cut a 5 inch piece of elastic. Sew each end of the elastic to the velvet side of each end of the glam band. Trim any extra. I used 3/8 black grosgrain for the casing. Just wrap your 3/8 black ribbon around the seam where the elastic meets the band to make a finished look.
You can adjust the measurements as you see fit if you want to do different sizes.
If you have any questions.. Please feel free to email me. I will help : )
Re: Softball Glitter Headband Tut
How've you been? Here's that headband pic you asked for! The stitches are actually made with black thread, but the flash made them look much lighter, almost white. Ask me if you have more ??
Last edited by Blkhawkfan; 10-08-2010 at 02:15.
|glam bands, glitter headbands, head bands, softball|