Thread: ribbon candies
View Single Post
  #1 (permalink)  
Old 01-15-2011, 07:03
elly760's Avatar
elly760 elly760 is offline
Senior Member
Join Date: Oct 2009
Location: McAllen, TX
Posts: 1,436
Default ribbon candies

Thanks to all that liked my idea and creation! Please feel free to use my instructions but PLEASE do not sell them off as your own in a tut! thanks!!

Step 1: take small foam ball and cut in half, I use my wood burning tool to do this. I tried a serragated knive but it made too much mess! I use the tip in the picture. If you go slow u can achieve to cut it in half and use both halves, it takes a little practice.

Step 2: cut 3 strands of 3/8 ribbon about 20 inches and heat seal the ends. Then glue each strand on top of each other and braid it. Once you get towards the end and can no longer braid secure it with a straight pin or you can sew it, I just secure it.

Step 3: glue the heat sealed side of the braid to the middle of the foam 'ball'

Step 4: place a small dap of glue and wrap the braid around the glued section
Attached Images
File Type: jpg 019.jpg (20.8 KB, 228 views)
File Type: jpg 020.jpg (112.9 KB, 223 views)
File Type: jpg 029.jpg (56.0 KB, 266 views)
File Type: jpg 030.jpg (64.0 KB, 256 views)
File Type: jpg 031.jpg (47.0 KB, 346 views)

Last edited by elly760; 01-16-2011 at 05:45.
Reply With Quote
Sponsored Links
wholesale rompers, dresses, bloomers, hat, headbands, leg warmers, flower layers, tulle, boutique clothing and other craft supplies