View Single Post
  #4 (permalink)  
Old 12-15-2010, 10:05
kelmac kelmac is offline
Senior Member
Join Date: Nov 2010
Posts: 2,156
Default Re: Applying a slider to a bow: horizontal or vertical bar

Originally Posted by Meghan View Post

what I actuallydo is cut a little piece of ribbon, seal the ends and glue it on the slider (over the center bar, under the sides) and then glue the whole shebang on the center of the bow. Some I do horizontally and some vertically, depends on what looks best when I put it together.

So basically you wrap a small piece of ribbon around the bar on the back of the slider and glue it? Does this mean you can skip the center ribbon and just glue it to the middle of the bow? Or do you do the ribbon center and glue the wrapped slider onto that?

Reply With Quote