View Single Post
  #1 (permalink)  
Old 02-10-2010, 02:37
staciem's Avatar
staciem staciem is offline
Senior Member
Join Date: Feb 2009
Posts: 416
Default Woodburner frustration - how to cut/seal ribbon?

I did a search and read through all the old threads about woodburners, including the tutorial one, but the pictures aren't showing up, so it wasn't too much of a help...

I just bought a woodburner earlier this week, and I broke it out yesterday to try for the first time. I placed my ribbon on a cookie sheet, laid my metal ruler down over the ribbon where I wanted to "cut" it, and then ran the tip of my woodburner slowly over the ribbon. I used the tip that looks like an exacto knife. I can't tell you how much ribbon I wasted trying to get it to work. Half of the time it didn't cut through the ribbon all the way, and when it did, it didn't seem to seal the ribbon in an even, clean line. Am I missing a step? Using the wrong tip? There's another angle tip that came with the tool, it's not an exacto knife edge, but it is angled. Should I try that?

Help and advice greatly appreciated!

Reply With Quote
Sponsored Links