View Single Post
  #1 (permalink)  
Old 07-22-2009, 11:24
thespotteddot thespotteddot is offline
Senior Member
Join Date: May 2009
Location: Arkansas - Woo Pig Sooie!
Posts: 310
Default Heat N Bond Question

I was fusing some ribbon together using heat n bond, but then afterwards it started peeling off. It said to just run the iron over for 2 seconds or so, but I did longer, thinking it would fuse better. However, after it started peeling away, I'm thinking I ironed too long. Does that happen?
Reply With Quote
Sponsored Links