View Single Post
  #5 (permalink)  
Old 12-18-2008, 09:09
SSC07 SSC07 is offline
Senior Member
Join Date: Jul 2008
Posts: 109
Default Re: How to make a heart clippie for valentines?

i've see one before on here too... I remember it going something like you cut two pieces of ribbon, and heat seal the ends. Glue the ends together on one end so that they make a "v" (the bottom of the v is where the glue is). Then you address the other end. Take the outsides of the V and turn them in towards the inside, and glue those two ends together. That will push the ribbon into that heart shape.

Did that make any sense at all? i sat here and did it and then tried to explain it, but i'm sure reading it you are going "WTH is she talking about".....

and if you can figure it out, just write down your ribbon measurements for use again later. easy peasy..
Reply With Quote