View Single Post
  #6 (permalink)  
Old 08-24-2008, 06:57
Sabine_in_MG's Avatar
Sabine_in_MG Sabine_in_MG is offline
Senior Member
Join Date: Mar 2008
Posts: 715
Default Re: Cutting and sealing ribbon ends pony o's

Take a metal ruler or straight edge, push it down pretty hard, squooshing your ribbon between the ruler and cutting surface, then quickly cut along the edge - don't let up on the ruler! .... it might pull a tiny bit but if the burner is really hot and you're using a fine tip it's usually not all that bad.

Reply With Quote