| | bottle caps
Ok so I have 2 questions. I have tried bottle caps with et lite and with the resin drops.
When I use the et lite about half come out right and the other half comes out with something wrong with them. Usually it is because dust gets in them. I have tried doing them in different places but it never fails about half are messed up. Is there anything or anyplace that would be better?
When using the resin drops they turn out good except at the edges I can't get them to look sealed. I press as hard as I can on them and the edges seem to still look like there is air underneath them. Is there a way to get this out.
Any advice would be much appreciated. If I can't figure these out I might just end up purchasing them from someone.