I turn the right sides together and place a single prong alligator clip to hole them together. I don't match the ends up perfectly, one just a little lower than the other...the one end that is lower, using my burner I kinda brush/melt it into the other side(making sure I don't melt all the way through) and then brush/melt the longer side on top of it? Does that make since, it's kinda hard to explain????? I wait a few seconds for it to cool and then I stretch it out, hold it up towarrds light to make sure it's completely heat sealed together. If not I just do it over. Maybe I can post a pic, if this doesn't make since.
Originally Posted by briellasnana
How do you do this? I have tried over and over again, alls I can get it to do, is just burn! lol
Do you fold one side to the other, do you have two ends together, then smash it or do you just cut with your wood burner tool and it just melts together? Man that elastic burning sure stinks!